Tema (Topic)

Status

D1

Power Supplies and Actuator-Converters for Future Robot Applications

D2

Integrated Actuator-Converter System for High Power Robot Applications

D3

High Power WBG Devices: Perspectives, Issues and Applications

D4

On-Line Monitoring and Diagnostic of High Power WBG Devices

D5

IGBT & MOSFET Gate Drivers: On-Chip Integration of Signal and Power

D6

Reverse Voltage Blocking Power Semiconductors: Perspectives, Issues and Applications

D7

Quantum-Mode Series Resonant Converters for High Frequency & High-Power Applications

D8

Partial Power Rated Converters for Ultra-Efficient/Dense Applications

Started in October 2019

Candidate: Igor Lopušina, i-PEL

D9

Multi-Cell Current-Source Converters: Analysis, Design and Application Perspectives

D10

Ultra-Dense Adapter & Charger for Cell-Phone and Lap Top Applications

To Start in Oct. 2020

D11

High Power Battery Charger for e-Mobility Applications

Started in October 2019

Candidate: Aleksandra Stanojević, i-PEL

D12

Ultra-Efficient & Dense 48 –to- 12V Automotive dc/dc Converters: Si & WBG Perspectives

D13

Ultra-Dense ac/dc Power Converters for Portable Equipment & Tools

D14

Analysis Design and Optimization of an Interface Power Converter for Energy Storage Grid Applications

D15

Modular MVDC Conversion System for 2MW Hybrid Micro Grid for 9km long Aerial Lift

D16

Multi-level & Multi-cell Power Converters for LV Power Quality Applications

Started in October 2019

Candidate: Zoran Miletić, AIT

Tema (Topic)

Status

М1

Development of a Single-Phase Half-Bridge Rectifier/Inverter with an Active DC Bus Capacitor

М2

Analysis & Design of an Automotive 48-to-12V dc/dc Converter

М3

Development of a Compact Military Grade 24 to 12V dc/dc Converter

М4

Failure Mode Analysis and Protection of a Three-Level NPC Converters

M5

Testing and Characterization of Cutting-Edge Power Semiconductors

M6

Analysis and Design of a Voltage Control Device for Low Voltage Distribution Transformers

M7

Topologies and Concepts of High-Power e-Mobility Chargers: An Overview and Comparative Analysis

M8

Development of an Active & Adjustable Dissipative AC Load Resistor

M9

Development of Power Supply and Drive Converter for Robot Applications

M10

Development of an Intelligent Control and Monitoring System for Agricultural Applications

M11

Development and Design of a Compact Power Supply for LED Applications

To Start in Feb. 2020

M12

Development and Design of a Power Converter for Grid Connected Permanent Magnet Synchro-Generators

M13

Development and Design of Battery Interface DC-DC Converter for Bipolar DC Microgrids

Tema (Topic)

Status

B1

Control of a spherical induction motor

B2

Induction Generators in Small Hydro Power Plants: Application Perspectives

B3

Smart Home Power Supply System based on Renewable Resources & Electro-chemical Batteries

B4

Voltage Quality Control in LV Distribution Networks: Power Electronics Approach

B5

Analysis and High-Level Design of a Voltage Control Device for LV Distribution Transformers & Networks

B6

DC Power Distribution for LV Home Applications: Perspectives and Issues

B7

Smart Agriculture: Irrigation System with Hybrid PV/Wind/Battery Power Supply and GSM/GPRS Monitoring and Control

Started in July 2019

Candidate: Tobias Pusnik

B8

GSM/GPRS Modem for Remote Monitoring and Control

B9

Power Conversion Control Platform based on ARM Cortex MCU

B10

Development of Low-Cost GSM/GPRS Sensor & Controller with PV & Battery Power Supply

B11

Power Converters for Grid Connected Permanent Magnet Synchro-Generators